The self-adaptive learning procedure consists in making the computer learn the physical characteristics of some of its peripherals. .Resetting the idle speed regulator: after disconnecting the computer or the battery, or after replacing the computer or after reprogramming it, it is necessary to reset the idle speed regulator.

 

For that:

 

1.Disconnect the battery for 20 minutes, after reconnecting the battery, wait at least 2 minutes before switching on the ignition, then start the engine and let it idle for a few seconds.1. Switch off the ignition for 15 seconds to reset the self-adapting devices.
2. Switch on the ignition and wait 15 seconds without touching the accelerator pedal (throttle learning).
3. Press the accelerator pedal fully for 5 seconds then release (learning full load stop).
4. Start the engine for 5 seconds without accelerating (slow learning).*
5. Switch off the ignition for 15 seconds to memorize the programming.
6. Switch the ignition back on, wait 15 seconds and start.
7. Let the engine idle, without accelerating, until the fans engage (optional).
8. Taxiing:
- with stabilized rolling at 70 km/h, 80 km/h and 90 km/h (adaptive linked to low air loads) for a minimum of 5 seconds on each level
- with passages in supercharged (full foot / full foot release / full foot release) in 3rd, 4th or 5th gear and then release the foot, without braking, to have an injection cut-off (5 seconds minimum).